Graphic Film Application
The Original Rapid
For fast, easy, quality installation of graphics with no bubbles, even
in cold weather.
Rapid Tac Application Fluid shocked installers by allowing them more
control over their applications than ever before. Now what took hours
could be accomplished in minutes. Using Rapid Tac Application fluid can
often allow a large graphic to be installed with one person where two
people were required to perform the same installation dry. Rapid Tac
Fluid also cleans the substrate without leaving residues
ensuring a contaminant free installation. It then helps to
vinyl film until it is properly positioned. Rapid Tac Application
Fluid’s best feature is that it effectively breaks the
of the adhesive on the film allowing it to flow and bond to the
substrate more effectively than even a dry application. It is now
possible to achieve a full bond in as little as ninety seconds. Your
customers and your reputation will benefit from higher-quality
applications. Your bottom line will benefit from faster applications
and less failures as well.
For removing adhesives quickly without damage or mess
Keeping it simple. When your faced with removing adhesive we have your
solution. Rapid Remover is a non-toxic, water-soluble adhesive remover
that breaks down and removes adhesives in as little as sixty seconds!
Spray it on, wait a few minutes and easily wipe away residue adhesive
with a plastic squeegee and paper towell. Not only is does Rapid
Remover work fast, but it works without causing damage to most painted
or bare metal surfaces. What may have been a four-hour job (and a messy
one at that) can now be cut in half with an easy, clean and
non-damaging removal. Gone are the days of using dangerous and risky
chemicals that often damaged painted surfaces, and had numerous health
hazards. Rapid Remover works. It’s that simple.
Colors: Blue with Felt Edge, Silver, Blue, White